how to fix a sagging door

The news that your door is sagging isn’t delightful. However, that is something you should not worry about that. Spare six minutes of your time to learn about the easiest ways to fix a sagging. The worst thing about sagging doors is that if you ignore them, they will bring about more issues that may cost you a lot of money.

A sagging door is something that someone with you can tackle with the very least DIY skills. let us have a look at the process of fixing a sagging door and getting a few troubleshooting ideas.

Are you wondering about the type of tools you need? You don’t need to put a lot of money on the apparatus. You’re fine if you have a screwdriver. Here’s a list of the tools you need

  • Wood glue
  • Screwdriver
  • Toothpicks

Don’t worry. We’re going to see why you need toothpicks.

Signs Of a Sagging Door

Your door is very likely to sag if you have your loose screws. Occasionally, you will find that the top hinge comes free as it holds the highest load.

You might also experience difficulties in opening the door or leaks near the edge of the door. The bottom or top of the door may also overlap the door frame.

Causes of sagging doors

Several factors contribute to damage to your door. The most common causes of a sagging door are:

Wearing off of hinge and bushings

Humid weather

Misaligned latch and sticker

The process of fixing a sagging door

1. Remove loose hinge screws

Hinge screws typically get slack over the years. Tighten the screws using a screwdriver. If you have loose screws, you can place a block of wood under the latch to make sure that it is sturdy while removing the screws.

2. Fills the screw holes

Screw holes may enlarge over time and may fail to hold the screws anymore. You can try to make the holes smaller by filling the gaps partially using a small piece of wood. This is where you need the toothpicks. Push them back to break off pieces that may have stuck for them to spread freely with the surface of the wood. Secure the toothpicks with wood glue

3. Return the screws

Now that the hole is smaller and the glue has is there to keep the wood intact, the screw is going to have the grip to support the door. Make sure the screws are tight but don’t overdo it.

You can now close the door and give room for the glue to dry. If there is excess glue that squeezed out, wipe it off.

However, sometimes where you may have a stripped screw, and toothpicks and glue will not solve the problem. Also, you may find out the screws used initially were not of the right size or length. If your door has small screws which cannot dig into the wood, your door will continue to sag. In this case, you have to replace the screws.

There you go. You don’t need to call a carpenter. That is just a simple remedy for a sagging door that will not take much of your time. Please don’t use too many toothpicks you might need them for dinner!

Leave a Reply

Your email address will not be published. Required fields are marked *